"fish eyes" in epoxy hot coat
Moderator: Moderator
"fish eyes" in epoxy hot coat
anyone know how to avoid fish eyes when hot coating with epoxy resin? I don't have any additives such as additive F. Just resin and hardner
Time and tide...
-
- Legend (Contribution King!)
- Posts: 726
- Joined: Fri Sep 26, 2003 5:33 am
- Location: San Diego, Vista
I would assume you have a contaminate in the substrate. Most fish eyes (from the auto paint world) are caused by silicone, oils, grease, etc. Any kind of wax, cleaners, etc that can leave airborne contaminates on the board could cause fish eyes. Try using an automotive paint finish oil and wax remover before hot coating the board.
Never leave well enough alone.
- tomway
- Ripper (more than 100 posts)
- Posts: 270
- Joined: Tue Nov 30, 2004 6:21 pm
- Location: South Sulawesi
- Contact:
Probably a bit late now Rippe, but my advice on this is that unless you are using an expensive surfboard resin or have additive F, I would do a poly hotcoat over your epoxy lam. Sanding epoxy makes you want to slit your wrists otherwise (unless you've got additive F which makes sanding gorgeous.)
So long as your lam is well sealed it'll be fine. I usually stick a kitchen scourer (white if you can get it) on the sanding pad of my sander/polisher and then set to the board making sure all the shinies are taken out of the epoxy making sure I get in to the weave. You can use a bit of hot water and soap if your epoxy has an milky/oily feeling to it (hardware store epoxies are like that sometimes, I think the correct term is "blush".) Then rinse, dry and hotcoat.
Don't believe the 'incompatible systems' hype. An epoxy finish will be lighter, and have a better bond, but in reality a well done poly hotcoat will last for the life of your board without chipping.![Cool 8)](./images/smilies/icon_cool.gif)
So long as your lam is well sealed it'll be fine. I usually stick a kitchen scourer (white if you can get it) on the sanding pad of my sander/polisher and then set to the board making sure all the shinies are taken out of the epoxy making sure I get in to the weave. You can use a bit of hot water and soap if your epoxy has an milky/oily feeling to it (hardware store epoxies are like that sometimes, I think the correct term is "blush".) Then rinse, dry and hotcoat.
Don't believe the 'incompatible systems' hype. An epoxy finish will be lighter, and have a better bond, but in reality a well done poly hotcoat will last for the life of your board without chipping.
![Cool 8)](./images/smilies/icon_cool.gif)