j.k. got two boards w/.... one w/o
Pad removal
Moderator: Moderator
-
gumby
- Legend (Contribution King!)
- Posts: 665
- Joined: Tue Aug 09, 2005 3:06 pm
- Location: Glendora CA.
Results
Pad removeal was not that bad. Single edge razor blade scraper and worked slowly. Left over adhesive used lift off spray and 2 1/2" paint scraper. Rolls up like boogers but will not flick. At the end I cleaned the board with comet clenser. Then wiped down with rubbing alcohol. Applyed new THE COVE DECK PAD per instructions. Finished edges with shure forn file. Time 3 1/2hr beer 3.6
Pad removeal was not that bad. Single edge razor blade scraper and worked slowly. Left over adhesive used lift off spray and 2 1/2" paint scraper. Rolls up like boogers but will not flick. At the end I cleaned the board with comet clenser. Then wiped down with rubbing alcohol. Applyed new THE COVE DECK PAD per instructions. Finished edges with shure forn file. Time 3 1/2hr beer 3.6
To do what I want to do
I have to do what have to do
Craig
I have to do what have to do
Craig